Auto Layout Question

Is there a way to tick every 52 inches? l< 52" >ll< 52" >ll< 52" >l . . . . Thanks, The Graco rep said you couldn't do it.

I disagree. simply setting the stall size at 4' .2" will give you a dot of 52.4" if that works. to go tighter go to the angle stall screen an it breaks it into 100ths rather than 10ths. I think you can tighten it up to 51.96". Randy V taught me this trick.

Thanks Cormac, that will work. That Randy is a sharp guy! Full of knowledge!!

Rock wrote on May 31, 2013:Go to #3

Thanks Cormac, that will work. That Randy is a sharp guy! Full of knowledge!!

He learnt a long time ago to not go by the book.

What book? There's a book? In the honesty of full disclosure and if my memory serves me correctly, Jim Panzenhagen (jpanz) was instrumental in brainstorming this solution. I seem to remember calling him and Cormac to figure this out but it was 5 years ago and I have a hard time remembering what happened yesterday at times.

I believe you were laying out pallet stalls. Somewhere around 390-400. Jim OR Randy, both good guys that make my job easier!

RandyV wrote on May 31, 2013:Go to #5

What book? There's a book?

Yea, I think it was written by some old guy and a pink monkey.

Never underestimate old guys or pink monkeys

Calif Striper wrote on May 31, 2013:Go to #8

Never underestimate old guys or pink monkeys

This old guy and pink monkey are from another planet.

straightline wrote on May 31, 2013:Go to #9

Calif Striper wrote on May 31, 2013:Go to #8

Never underestimate old guys or pink monkeys

This old guy and pink monkey are from another planet.

Another planet? Probably liberals.

Calif Striper wrote on Jun 1, 2013:Go to #10

straightline wrote on May 31, 2013:Go to #9

Quote from: Calif Striper on June 01, 2013, 12:05:35 AM Never underestimate old guys or pink monkeys This old guy and pink monkey are from another planet.

Another planet? Probably liberals.

Yea, probably, they did follow this other old guy blindly.

Thanks for the replies guys !

You could just hit the measure lot button and push it 52 inch and set it for one stall. Unless I miss understood.