(poll) Do you charge for...

Archived, read-only

Discussion in Striping & Marking started by ses9ball (unclaimed legacy handle), Dec 15, 2005. 43 replies, last reply Jan 1, 2006.

Page 3 of 3
BornToStripeUnclaimed legacy handle
BornToStripeUnclaimed legacy handle

Northern Tool has a 300' Nylon clad steel for $65 in store. Could not find it on their website.

BornToStripe, Report#41
ChrisUnclaimed legacy handle
ChrisUnclaimed legacy handle

Thanks for the info. That is a good price,$65.00 is cheaper than I have found. I have found some 300' fiberglass at Lowe's for $21.99 but it has a lifetime guarantee and if it stretches or fails in any way just take it back to the store. I am sure you have to keep the receipt forever. It is not the fast rewind kind. They have a Stanley 300' for $24.99 but not the warranty like the generic but it has the fast rewind and I tried it out and the gears were not grabbing that good so I am sure they would strip pretty quickly.

Chris, Report#42
ses9ballUnclaimed legacy handle
ses9ballUnclaimed legacy handle

thanxs for the info. i think maybe engine speed might be it . i run my speed at 2/3 to 3/4 , probally to much . thanxs again

ses9ball, Report#43
\\\STRIPES///Unclaimed legacy handle
\\\STRIPES///Unclaimed legacy handle

It happens pretty often especially if you stripe using a pusher machine.

\\\STRIPES///, Report#44
Page 3 of 3

This archived thread is closed to replies.

Members can pick it up in the member forum: a new thread that quotes this one and links back here.

From the Parking Lot Planet archive, 2005 to 2016. About this archive Report a post