rear axle spaying

Archived, read-only

Discussion in Striping & Marking started by Lorne (unclaimed legacy handle), Jun 1, 2005. 2 replies, last reply Jun 2, 2005.

LorneUnclaimed legacy handleStarted the thread
LorneUnclaimed legacy handle, started the thread

I'm using the HS 200 and linedriver , does any one spray form the rear axle and still apply glass bead. What tip size should I use with the line driver for 4 in lines on pavement? Thanks Lorne

Lorne, Report#1
RobertUnclaimed legacy handle
RobertUnclaimed legacy handle

Do you have a LineLazer IV 200HS with the rear gun mount? If so you can apply beads with the gun at the rear. I like to run with the gun at the rear, but until the IV, you couldn't apply beads, because the bead dispenser would be ahead of the gun. What size tip? 4-19 if you want to go slow, 4-21 or 23 if you want to travel faster.

Robert, Report#2
LorneUnclaimed legacy handle
LorneUnclaimed legacy handle

I've got the Linelazer III, I'll have to look into to attaching rear mount gun holder,simmilar to the IV. Ld

Lorne, Report#3

This archived thread is closed to replies.

Members can pick it up in the member forum: a new thread that quotes this one and links back here.

From the Parking Lot Planet archive, 2005 to 2016. About this archive Report a post