painted-arrowUnclaimed legacy handleStarted the thread
Striping angle lines on curve (60 degree)
Archived, read-only
Discussion in Tips & Tricks started by painted-arrow (unclaimed legacy handle), Aug 17, 2015. 1 reply, last reply Aug 17, 2015.
IstripeitUnclaimed legacy handle
IstripeitUnclaimed legacy handle
May be some folks on here with a better way to do this, I have used the tape measure to make two intersecting arcs, to get the 60 degree point, look online if you have not done this, once you have a good looking 60 on two adjacent stalls, measure the distance around the inside of the radius, then as you go around the outside of the radius you will have to make sure you keep the angle by checking it several times as you lay it out.
This archived thread is closed to replies.
Members can pick it up in the member forum: a new thread that quotes this one and links back here.
Continue this discussion
Continuing the archived discussion Striping angle lines on curve (60 degree). Your thread opens in the member forum and links back to it.
PLSIC members start threads here. It is free for striping contractors and property owners; the panel beside this page has the two ways to join.
From the Parking Lot Planet archive, 2005 to 2016. About this archive Report a post